CCTV Power supplies & batteries  (658)

External DC power supply. Provides system power to one OS6570-12 switch.

All OmniSwitch 6900 models support 1+1 redundant, hot-swappable AC and DC power supplies. The primary and backup power supply units are internal, but removable to allow for easier maintenance and replacement. There is no service interruption when a new power supply is installed or an old one replaced. All OS6900 models ship with two redundant power supply units. 

240 input, Power Supplies & Batteries

The Q8 Power is an 8 channel wall or 19" rack mount unit and is specifically designed for powering any camera within the Q EYE camera range/ BNC connections out are provided for video distribution to multiplexers and monitors with pluggable terminal entries for cameras. The unit will power up to 8 cameras to a maximum distance of 200m and is BS EN60529 IP10 rated.

The Q1 Power is a 1-channel wall mount unit and is specifically designed for powering 1-camera within the Q EYE camera range. It can receive 230 VAC mains locally to the camera installation. Powering the camera module and sending control and video back to the control end via standard co-axial or twisted pair. This unit is weatherproof to BS EN60529 IP66.

Verkada 4AH Backup Battery

AC62 18AH Backup Battery

ACC–POE–60W high surge (HS) PoE++ injector

Products are in compliance with NDAA Section 889 Part B Guidelines

12V 500mA Power Supply Replacement 12V 500mA DC Plug-in Power Supply with screw terminals for XTL Series control panels. For use with: XTLplus and XTLtouch Control Panels

External lightning suppressor for use with any DMP or other manufacturer's panel. Provides transient protection and RF isolation on both AC power and telephone lines. Phone lines connect to modular jacks while AC and ground wires connect to on-board terminal strips. For use with: All DMP XT Series and XR Series Panels

12 Volt DC 600 MA Adapter For use with: 1117 and 1118

Used in conjunction with Ethernet switch to power PoE cameras Meets IEEE 802.3af/at Ethernet standard Ethernet speeds up to 10/100/1000 Mbps

12 VDC, 7.0 sealed lead-acid battery. (PKG of 4). For use with: All XT and XR Series Panels.

5.0 Ah, 12 VDC sealed lead-acid battery. (PKG of 10). For use with: All XT and XR Series Panels.

12 VDC, 18.0 Ah sealed lead-acid battery. (PKG of 2). For use with: All XT and XR Series Panels.

12 VDC, 9.0 Ah sealed lead-acid battery. (PKG of 4) For use with: All XT and XR Series Panels.

12 VDC, 1.3 Ah sealed lead-acid battery. (PKG of 20) For use with: All XT and XR Series Panels.